|Published (Last):||11 December 2009|
|PDF File Size:||19.6 Mb|
|ePub File Size:||13.43 Mb|
|Price:||Free* [*Free Regsitration Required]|
A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. It is the responsibility of the user of this standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use.
Reference Standards 2. Current edition approved June 10, Published August Originally published as D — Last previous edition D — 93 Take special precautions while determining the odor of all products. Make the tests only as frequently as is necessary for control and base the evaluations on short sniffs, inhaling as little vapor as possible. Procedures 5. Permit the papers to dry in air at room temperature and examine them at suitable intervals for differences in odor see 1.
Report 6. It is assumed that the standard, which is acceptable to both consumer and producer, has no detectable residual odor. Precision and Bias 7. Some analysts have little olfactory sensitivity to some materials, while other analysts have extreme sensitivity to either the main or if any minor component.
In either case, the accuracy of odor measurements D should be considered suspect. In case of differing results between purchaser and supplier, it may be helpful to employ an odor panel consisting of no less than three persons. Keywords 8. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phone , fax , or service astm.
ASTM D1296 - 01(2012)
ASTM D1296 PDF